Description

The FREUD DHS3125 is a 3-1/8 inch diameter hole saw designed for high-performance boring through wood and metal. It delivers a maximum cutting depth of 2-3/8 inches, allowing most holes to be completed in a single pass without repositioning. The variable tooth design reduces vibration during the cut and improves cutting speed. A tool-free plug ejection system clears cut material quickly without stopping work. The Snap Lock system allows fast, no-tool bit changes, reducing downtime between cuts. This saw is suited for licensed electricians, plumbers, HVAC technicians, and general contractors who need reliable, repeatable hole sizing on the job site.

The DHS3125 is built for use in wood framing, metal studs, sheet metal, and similar trade materials encountered in residential and light commercial construction and service work. It is compatible with the Snap Lock mandrel system, where one mandrel fits all Diablo hole saws ranging from 5/8 inch to 6 inches in diameter. Note that the mandrel and pilot bit are sold separately and are required for operation. This saw suits applications where a clean, accurately sized hole is needed in a single boring pass.

Key Features

3-1/8 inch cutting diameter for standard trade hole sizing in wood and metal
2-3/8 inch cutting depth allows through-boring in a single pass on most materials
Variable tooth design reduces vibration and increases cut speed
Tool-free plug ejection clears waste material without stopping work
Snap Lock system enables fast mandrel changes with no tools required
Compatible with the universal Snap Lock mandrel fitting Diablo hole saws from 5/8 inch to 6 inches diameter

Compatibility

Works with the Snap Lock mandrel system that fits all Diablo hole saws from 5/8 inch to 6 inches in diameter. Mandrel and pilot bit are sold separately. Rated for use in wood and metal materials.

Installation Notes

This hole saw is installed and used by electricians, plumbers, and HVAC technicians for rough-in boring through framing, panels, and metal substrates. Always disconnect power or de-energize the work area before boring near electrical components. Secure the workpiece before drilling and use appropriate eye and hand protection. The mandrel and pilot bit must be installed before use per the mandrel manufacturer instructions.