Description

The CHARLOTTE PIPE FOUNDRY CO. PVC 01300 0600HA is a 3-inch PVC DWV 90-degree sanitary elbow rated for Schedule 30 applications. This fitting connects drain, waste, and vent lines at a 90-degree turn using a hub-by-hub configuration, accepting pipe into both ends for a solvent-welded joint. It is a standard component in residential and light commercial drain systems and is typically installed by licensed plumbers during rough-in or repair work. The Schedule 30 wall construction meets DWV service requirements without the added mass of Schedule 40, making it well-suited for above-ground drainage piping.

This elbow is used in drain, waste, and vent piping systems where a sharp 90-degree direction change is required. The sanitary sweep pattern supports proper drainage flow and reduces the likelihood of solids buildup at the fitting transition. Common installation scenarios include under-sink drain connections, horizontal-to-vertical stack transitions, and branch line routing in wall or ceiling assemblies. This fitting is sold in a package quantity of 10 units, making it practical for new construction or multi-unit service calls.

Key Features

90-degree sanitary elbow geometry supports smooth drainage flow in DWV systems
Hub x Hub ends accept solvent-cement connections on both sides
Schedule 30 PVC construction meets standard above-ground DWV service requirements
3-inch pipe size fits common residential and light commercial drain lines
Packaged in quantities of 10 for jobsite efficiency

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 3-inch Schedule 30 PVC DWV piping systems in above-ground residential and light commercial drain, waste, and vent applications.

Installation Notes

Installation is performed by a licensed plumber following local plumbing code and IPC requirements. Shut off water supply and ensure the drain line is empty and dry before cutting into existing piping. Use appropriate PVC primer and solvent cement rated for DWV applications, and allow full cure time before restoring flow. Do not use this fitting on pressurized supply lines.